X Series E83 X3 2.0d (N47) OFFRD
Remove transmission cross-member.
Unlock bearing pin (1) in direction of arrow and remove.
Lift out shift arm.
Installation:
Grease bearing pins (1).
Grease, refer to BMW Service Operating Fluids.
Note:
Illustrations show E60.
Lift off retainer (1).
Disconnect shift rod (2).
Installation:
Grease shift rod.
Grease, refer to BMW Service Operating Fluids.
Make sure shims (3) are in correct position.
Release screws.
Tightening torque 23 00 1AZ
.
Important!
Do not allow transmission to hang from the transmission input
shaft when removing and installing, as the clutch disk will be
deformed. Pull transmission downwards and remove.
RA Removing and installing transmission (GS6-37BZ) N47
BMW AG - TIS
05.02.2013 23:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -