Z Series E85 Z4 2.5Si (N52) ROADST
Disconnect plug connection (1).
If necessary, disconnect plug connection (2) on ride-height
sensor and expose lead up to penetration to luggage
compartment.
Warning!
Danger of injury!
Failure to comply with the following instructions may result
in the vehicle slipping off the lifting platform and critically
injuring other persons.
When supporting components, make sure that
•
the vehicle can no longer be raised or lowered
•
the vehicle does not lift off the locating plates on the
lifting platform
Support rear differential with workshop jack and special tool
33 4 420 .
Important!
Observe gap between special tool 33 4 420 and dust
plates (1).
To avoid grinding noises, make sure the dust plates (1) are
not damaged (e.g. bent).
Remove tension strut.
Release screws and remove stop plate.
Lower rear axle carrier.
Installation:
Check threads for damage; if necessary, repair with Helicoil thread
inserts.
Check seating of coil springs with spring pads, correct if
necessary.
Tightening torque 33 33 3AZ
.
RA Lowering/raising rear axle carrier
BMW AG - TIS
13.02.2013 12:44
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -