Z Series E85 Z4 3.0i (M54) ROADST
11 00 670
Securing engine in installation position (M54)
Special tools required:
•
00 0 200
•
00 0 202
•
00 0 204
•
00 0 208
•
00 0 451
•
11 0 020
Warning!
Danger of injury!
Observe following instructions relating to special tool:
1.
Prior to each use, check the special tools for defects,
modifications and operational reliability.
2.
Damaged/modified special tools must not be used!
3.
No changes or modifications may be made to the special
tools!
4.
Keep special tools dry, clean and free of grease.
Necessary preliminary tasks:
•
Secure engine bonnet/hood in service position
•
Remove engine cover
•
Place wiring harness on rear of cylinder head to one side, cut
through cable tie if necessary.
Assemble cross member 00 0 200 with special tools 00 0 202 ,
00 0 204 , 00 0 208 .
Modification:
Replace profile strips with special tools 00 0 451 .
RA Securing engine in installation position (M54)
BMW AG - TIS
15.02.2013 10:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
