Z Series E85 Z4 3.0i (M54) ROADST
11 13 000
Removing and installing, sealing or replacing
oil sump (M54)
Necessary preliminary tasks:
•
Remove intake filter housing
•
Remove guide tube for oil dipstick
•
Lowering front axle support
•
Drain off engine oil
•
Disconnect plug connection to oil level sensor.
On vehicles with automatic transmission:
Detach oil lines from automatic transmission and from oil pan.
Unfasten oil pan screws at transmission and engine ends.
Lower and remove oil pan.
Installation:
Sealing faces clean and free of seal debris.
Apply approx. 3 mm wide, 2 mm high coat of Drei Bond 1209
sealing agent (refer to BMW Parts Service) to the area around
seams.
RA Removing and installing, sealing or replacing oil sump (M54)
BMW AG - TIS
15.02.2013 10:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
