Enclave FWD V6-3.6L (2008)
4. Ensure the proper timing mark is used. Observe the outer ring of the camshaft position actuator for the circle marking (1).
The circle marking is for alignment to the highlighted timing chain link on the left side of the engine.
Notice: A wrench must be used on the hex of the camshaft when loosening or tightening in order to prevent component damage. Failure to prevent
the torque reaction against the timing drive chain can lead to timing drive chain failure.
5. Use an open wrench on the hex cast into the camshaft in order to prevent camshaft rotation when tightening the camshaft position actuator bolt.
6. Locate the intake camshaft position actuator to the camshaft and loosely install the bolt.
Important: Camshaft thrust washers must be installed on all 2007-2008 applications when servicing the camshaft position actuators, even if not
originally equipped with thrust washers
7. Install the camshaft thrust washer.
