Park Avenue V6-3.8L SC VIN 1 (2005)
8. Disconnect the electrical harness conduit wire ties from the engine frame.
9. Remove the battery positive cable from the electrical harness conduit.
10. Remove the battery positive cable from the vehicle.
INSTALLATION PROCEDURE
1. Install the battery positive cable into the electrical harness conduit.
2. Connect the electrical harness conduit wire ties to the engine frame.
3. Install the nut securing the battery positive cable to the starter.
Tighten the battery positive cable to starter nut to 10 N.m (89 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
4. Lower the vehicle.
5. Install the nut securing the battery positive cable to the battery positive terminal on the underhood fuse block.
Tighten the battery positive cable to underhood fuse block nut to 15 N.m (11 lb ft).
