Rainier AWD L6-4.2L VIN S (2005)
2. Remove the screws (2) retaining the rear body control module (BCM) (1) to the endgate.
3. Disconnect the electrical connectors from the rear BCM.
4. Remove the module from the vehicle.
Installation Procedure
1. Install the rear BCM (1) to the endgate.
2. Connect the electrical connectors to the module.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the screws (2) retaining the rear BCM to the endgate.
Tighten the rear BCM screws to 2.5 N.m (22 lb in).
4. Install the trim panel to the endgate.
