Regal V6-231 3.8L VIN L SFI (1990)
Refer to Fig. 168, when performing this procedure.
1.
Disconnect battery ground cable.
2.
Remove speaker grilles by prying carefully at edge of grille.
3.
Remove one instrument panel pad cover retaining screw from under each speaker grille, Fig. 169.
4.
Remove five screws under lower edge of instrument panel pad.
5.
Remove pad by lifting front, pulling rearward to release, then lifting up and out.
6.
Remove two speaker retaining bolts, then disconnect electrical connectors and remove speakers.
7.
Remove one cluster trim plate retaining bolt on left side, then the trim plate.
8.
Remove electrical connectors, then six cluster retaining bolts and the cluster.
9.
With glove box open, remove gasket from around air outlet.
10.
Remove two screws behind gasket, then open fuse block cover.
11.
Remove two glove box retaining screws, located on the left side of glove box.
12.
Disconnect electrical connector, then remove glove box.
13.
Remove three bolts holding right side sound insulator.
14.
Remove insulator by pushing towards front of car, then pulling down.
15.
Remove four ventilation control assembly retaining bolts, then the control assembly and connectors.
Fig. 170 Removing Radio Control
Fig. 171 Cassette & Equalizer Removal
