Rendezvous V6-3.5L (2007)
11. Remove the windshield reveal molding.
Grasp the lower corner of the windshield reveal molding by hand and slowly pull the reveal molding away from the windshield.
12. If the windshield reveal molding will not release, use a utility knife in order to cut around the windshield in order to remove the windshield reveal
molding.
13. Remove the lower windshield supports (1) from the cowl panel, if equipped.
Important: Keep the cutting edge of the tool against the window.
14. This will allow the urethane adhesive to be separated from the window.
* Leave a base of urethane on the pinchweld flange.
* The only suitable lubrication is clear water.
* Use the J 24402-A, J 39032 or equivalent in order to remove the window.
15. Remove the bottom of the window from the urethane adhesive using a long utility knife or similar tool. Keep the cutting edge of the utility knife
against the glass. Do this from inside the vehicle.
