Rendezvous AWD V6-3.4L VIN E (2005)
Throttle Cable/Linkage: Service and Repair
Accelerator Controls Cable Bracket
ACCELERATOR CONTROLS CABLE BRACKET REPLACEMENT
REMOVAL PROCEDURE
1. Disconnect the accelerator cable cross slug from the throttle body lever.
2. Disconnect the accelerator cable from the accelerator cable bracket.
3. Disconnect the cruise control cable from the throttle lever and accelerator bracket, if applicable.
4. Remove the nut (3) and bolts (1, 2) holding the accelerator cable bracket to the throttle body.
5. Remove the accelerator cable bracket.
INSTALLATION PROCEDURE
1. Position the accelerator cable bracket on the throttle body.
2. Install the nut (3) and bolts (1, 2).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the bolts in sequence (2, 1) to 13 N.m (115 lb in).