Rendezvous FWD V6-3.5L VIN L (2006)
2. Use a heat gun J 25070 .
Important: Do not touch the adhesive backing on the molding.
3. Remove the protective liner from the back side of the rear quarter panel molding.
4. Position the rear quarter panel molding to the rear quarter panel.
5. Install rear quarter panel molding starting at the D-pillar and working forward and locating the push-in retainers to the rear quarter panel, pressing
rear quarter panel molding into place until fully seated.
6. Install the upper edge of the rear quarter panel molding by applying pressure to the entire length of the molding starting at the rear and working
forward in order to ensure a maximum bond to the rear quarter panel.
7. Install the push-in retainers to the inside rear edge of the rear quarter panel molding.
8. Close the endgate.
