Riviera V6-231 3.8L VIN C SFI (1989)
Lower Side Moulding / Trim: Technical Service Bulletins
Exterior Trim - Body Side Molding Thickness Increased
Bulletin:
89-10-26
Date:
Sept. '89
Ref. No.: 89-219-10
Corp. Ref. No.: 901503R
SUBJECT:
RIVIERA BODY SIDE MOLDING THICKNESS INCREASED (NEW PARTS)
MODELS AFFECTED:
1989 RIVIERAS
The body side moldings used on Rivieras were originally manufactured in stainless steel in a thickness of .46-.50 mm. To improve the ability to resist
denting, a new molding is being released for service. The new molding has a gage thickness of .54-.60 mm. Part numbers for these moldings are listed
below:
Front Fender
Right/Left
20729258/-9
Door
Right/Left
12500994/-3
Rear Quarter
Right/Left
12394244/-5
Parts are currently available from GMSPO.
