Riviera V6-231 3.8L VIN C SFI (1989)
Figure 1 - Locating Beta Brace Patch
8.
Locate the beta brace patch as follows:
A.
Butt the forward edge of the patch against the rear edge of the number 2 and number 3 bar weld flanges. Refer to Figure 1.
B.
The inboard edge of the patch will be located at the lower surface of the center tunnel radius.
C.
The rear edge of the patch will locate next to the body wiring harness conduit assembly.
D.
Apply heat (by means of the air gun) directly to the surface of the beta brace patch for approximately 12-14 minutes.
E.
Remove the heat source and allow the material to cure for approximately 30-45 minutes.
9.
Following Completion of the Material Curing (Hardening):
A.
Install insulation material between the number 2 and number 3 floor pan bars.
B.
Position floor carpet assembly in the original position.
