Skylark L4-144 2.4L DOHC VIN T SFI (1997)
Power Steering Pump: Service and Repair
Face Seal
CAUTION: This procedure is completed without the disassembly of the pump.
REMOVAL
Remove or disconnect the following:
1. Pump assembly from vehicle.
2. Face seal (11) from pump. Lift seal from face of pump housing (10). Separate from shaft seal and pilot assembly in housing. Do not damage
housing surface under flat face of seal.
INSTALLATION
Install or connect the following:
1. Face seal to pump. Locate seal on shaft seal and pilot assembly in housing. Seal is installed properly with either side out.
2. Pump assembly into vehicle.
