CTS RWD V8-6.2L SC (2009)
1. Place the ignition switch in the OFF position.
2. Remove the RH front compartment sight shield. Refer to Front Compartment Sight Shields Replacement (See: Body and Frame/Spoilers, Flaps,
and Air Dams/Air Dam/Service and Repair/Front Compartment Sight Shields Replacement).
3. Thoroughly clean the area around the EBCM of all dirt and debris.
4. Disconnect the secondary brake pressure modulator valve (BPMV) inlet brake pipe fitting (1).
Cap the brake pipe fitting and plug the BPMV inlet port to prevent brake fluid loss and contamination.
5. Disconnect the primary BPMV inlet brake pipe fitting (1).
Cap the brake pipe fitting and plug the BPMV inlet port to prevent brake fluid loss and contamination.
6. Remove the electronic brake control module (EBCM). Refer to Electronic Brake and Traction Control Module with Brake Pressure Modulator
Valve Replacement (CTS) (See: Electronic Brake Control Module/Service and Repair)Electronic Brake and Traction Control Module with Brake
Pressure Modulator Valve Replacement (CTS-V) (See: Electronic Brake Control Module/Service and Repair).
