CTS RWD V8-6.2L SC (2009)
3. Install the EBCM screws (1).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Tighten the EBCM screws in the sequence shown (1-4) to 5 Nm (44 lb in).
5. Connect the EBCM electrical connector.
6. Position the washer solvent container and install the fasteners. Refer to Windshield Washer Solvent Container Replacement (With CE4) (See:
Wiper and Washer Systems/Windshield Washer Reservoir/Service and Repair/Windshield Washer Solvent Container Replacement (With CE4)
)Windshield Washer Solvent Container Replacement (Without CE4) (See: Wiper and Washer Systems/Windshield Washer Reservoir/Service
and Repair/Windshield Washer Solvent Container Replacement (Without CE4)).
7. Install the right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement (See: Body and Frame/Fender/Front Fender/Front Fender
Liner/Service and Repair).
8. Lower the vehicle.
9. If installing a new EBCM, program the EBCM. Refer to Control Module References (See: Testing and Inspection/Programming and Relearning).
10. Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle).
Brake Pressure Modulator Valve Replacement (CTS)
Brake Pressure Modulator Valve Replacement (CTS)
Removal Procedure
Warning: Refer to Brake Fluid Irritant Warning (See: Service Precautions/Technician Safety Information/Brake Fluid Irritant Warning).
Caution: Refer to Brake Fluid Effects on Paint and Electrical Components Caution (See: Service Precautions/Vehicle Damage Warnings).
Caution: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON
position.