CTS Sedan AWD V6-3.0L (2010)
2. Install the brake caliper (1).
Note: If reusing the brake caliper guide pin bolts, the threads of the brake caliper guide pin bolts and the threads of the guide pins must be free of
residue and debris prior to application of threadlocker in order to ensure proper adhesion and fastener retention.
3. If reusing the caliper pin bolts, prepare the bolts and the guide pins for assembly:
*
Thoroughly clean the residue from the guide pin bolt threads by using denatured alcohol or equivalent and allow to dry.
*
Thoroughly clean the residue from the guide pin threads by using denatured alcohol or equivalent and allow to dry.
4. Apply threadlocker GM P/N 12345493 (Canadian P/N 10953488), or equivalent to 2/3 of the threaded length of the brake caliper guide pin bolts.
Ensure there are no gaps in the threadlocker along the length of the filled area of the bolts.
5. Allow the threadlocker to cure approximately 10 minutes before installation.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
6. Using a backup wrench on the brake caliper guide pin, install the brake caliper guide pin bolts (1) and tighten to 60 Nm (44 lb ft).
