CTS Sedan AWD V6-3.0L (2010)
Brake Caliper: Removal and Replacement
Front Brake Caliper Replacement (JE5, J55)
Front Brake Caliper Replacement (JE5, J55 (AWD))
Removal Procedure
Warning: Refer to Brake Dust Warning (See: Service Precautions/Technician Safety Information/Brake Dust Warning).
Warning: Refer to Brake Fluid Irritant Warning (See: Service Precautions/Technician Safety Information/Brake Fluid Irritant Warning).
Caution: Refer to Brake Fluid Effects on Paint and Electrical Components Caution (See: Service Precautions/Vehicle Damage Warnings).
1. Inspect the fluid level in the brake master cylinder reservoir.
2. If the brake fluid level is midway between the maximum full point and the minimum allowable level, no brake fluid needs to be removed from the
reservoir before proceeding.
3. If the brake fluid level is higher than midway between the maximum full point and the minimum allowable level, remove brake fluid to the midway
point before proceeding.
4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
5. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair
).
6. Install a C-clamp against the outer brake pad and the rear of the brake caliper body.
7. Slowly tighten the C-clamp until the brake caliper pistons are compressed into the brake caliper bores.
8. Using a backup wrench on the brake caliper guide pin, remove the brake caliper guide pin bolts (1).
