CTS Sedan AWD V6-3.0L (2010)
5. Connect the master cylinder secondary brake pipe fitting (1) and tighten the fitting to 36 Nm (27 lb ft).
6. Connect the master cylinder primary brake pipe fitting (1) and tighten the fitting to 36 Nm (27 lb ft).
7. Connect the brake fluid level indicator switch electrical connector.
8. Rotate the air inlet panel and position the support bracket to the master cylinder mounting stud.
9. Install the air inlet panel support bracket push nut.
10. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) (See: Brake Bleeding/Service and Repair)Hydraulic
Brake System Bleeding (Pressure) (See: Brake Bleeding/Service and Repair).
