CTS Sedan AWD V6-3.0L (2010)
3. Select Chassis
4. Select Parking Brake Control Module
5. Select Module Setup
6. Select Parking Brake Calibration
5. The EPB module will be calibrated and proper tension will be applied to the parking brake cables.
Without Scan Tool - Optional Method
1. Block the drive wheels.
2. Turn the ignition switch to the ON/RUN position with the engine OFF.
3. Apply the brake pedal.
4. Place the automatic transmission in PARK or manual transmission in NEUTRAL, as equipped.
5. Momentarily lift then release the EPB switch to apply the EPB.
6. Momentarily press down then release the EPB switch to release the EPB.
7. Repeat step 5 and 6 to cycle the EPB on then off an additional 4 times.
8. The EPB module will be calibrated and proper tension will be applied to the parking brake cables.
