CTS Sedan AWD V6-3.0L (2010)
Fuel Injector: Service and Repair
Fuel Injector Replacement
Fuel Injector Replacement
Special Tools
*
EN-47909 - Injector Bore and Sleeve Cleaning Kit
*
EN-48266 - Injector Seal Installer and Sizer
*
J 2619-01 - Slide Hammer
*
J-37281-A - Injector Remover
*
J 39313 - Spark Plug Port Adapter
Removal Procedure
1. Relieve the high side fuel system pressure. Refer to Fuel Pressure Relief (See: Fuel Filter/Fuel Pressure Release/Service and Repair).
Note: The fuel injectors have an alignment feature, note the position of the injectors alignment for installation.
2. Remove the fuel injection fuel rail assembly. Refer to Fuel Injection Fuel Rail Assembly Replacement - Bank 1 (LF1) (See: Fuel Rail/Service and
Repair/Fuel Injection Fuel Rail Assembly Replacement - Bank 1)Fuel Injection Fuel Rail Assembly Replacement - Bank 1 (LLT) (See: Fuel
Rail/Service and Repair/Fuel Injection Fuel Rail Assembly Replacement - Bank 1) or Fuel Injection Fuel Rail Assembly Replacement - Bank 2
(LF1) (See: Fuel Rail/Service and Repair/Fuel Injection Fuel Rail Assembly Replacement - Bank 2)Fuel Injection Fuel Rail Assembly
Replacement - Bank 2 (LLT) (See: Fuel Rail/Service and Repair/Fuel Injection Fuel Rail Assembly Replacement - Bank 2).
3. Remove and discard the three fuel injector retaining rings (1).