CTS Sedan AWD V6-3.0L (2010)
Fuel Injector: Service and Repair
Fuel Injector Sight Shield Replacement
Fuel Injector Sight Shield Replacement (LP1, LY7)
Removal Procedure
1. Remove the cross car brace, if necessary. Refer to Cross Vehicle Brace Replacement (See: Body and Frame/Frame/Cross-Member/Service and
Repair).
2. Remove the oil fill cap.
3. Disengage the cover/shield from the ball studs by pulling up firmly on the right rear and left front of the engine cover.
4. Remove the engine cover/sight shield.
5. Remove the front compartment sight shield, if necessary. Refer to Front Compartment Sight Shields Replacement (See: Body and
Frame/Spoilers, Flaps, and Air Dams/Air Dam/Service and Repair/Front Compartment Sight Shields Replacement).
Installation Procedure