CTS Wagon RWD V6-3.6L (2010)
5. Install the power steering gear inlet hose latch plate bolt and tighten to 22.5 Nm (17 lb ft).
6. Clean any excess fluid from the vehicle and remove the drain pans.
7. Install the front air deflector. Refer to Front Air Deflector Replacement (See: Body and Frame/Spoilers, Flaps, and Air Dams/Air Dam/Service
and Repair).
8. Install the front compartment lower noise shield. Refer to Front Compartment Lower Noise Shield Replacement (All Wheel Drive) (See: Body
and Frame/Splash Guard/Service and Repair/Front Compartment Lower Noise Shield Replacement)Front Compartment Lower Noise Shield
Replacement (Rear Wheel Drive) (See: Body and Frame/Splash Guard/Service and Repair/Front Compartment Lower Noise Shield Replacement
).
9. Install the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement (See: Body and Frame/Fender/Front Fender/Front Fender
Liner/Service and Repair).
10. Fill and bleed the power steering system. Refer to Power Steering System Bleeding (See: Power Steering Bleeding/Service and Repair).
