DeVille DHS V8-4.6L VIN Y (2000)
12. Cut the engine harness conduit (1) at the shown location.
Important: Leave a sufficient amount of wiring so that the new jumper terminals can be assembled.
13. Cut the 2 twisted dark green and tan wires.
14. Pull the ends of the wires on the engine side out of the conduit.
Installation Procedure
Important: Maintain the twisting of the wheel speed sensor wires.
1. Install the terminals (2) and cable seals (3) to the engine side of the wire. Refer to Wiring Repairs in Diagnostic Aids.
2. Install the connector (1) and terminal position assurance (4) to the engine side of the wire. Refer to Wiring Repairs in Diagnostic Aids.
3. Install the wheel speed sensor jumper connector (1) to the assembled connector (2).
4. Cut the tape on the wheel speed sensor jumper (4).