DeVille DHS V8-4.6L VIN Y (2000)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor Jumper Harness Replacement - Front (Right)
Removal Procedure
Important: The wheel speed sensor wiring is included in the engine harness. The wiring between the wheel speed sensor and the heat shrink sealed
splices is high-flex cable and must not be repaired or spliced. This procedure replaces the high-flex cable with a jumper harness from a supplied repair
kit.
1. Turn OFF the ignition.
2. Raise the vehicle. Refer to Vehicle Lifting.
3. Remove the right front wheel. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
4. Remove the wheel speed sensor connector (7) from the wheel speed sensor (6).
5. Remove the harness grommet (3) from the strut bracket (5).
6. Remove the harness grommet (1) from the rail bracket (2).
7. Remove the harness clip (4) from the rail bracket (2).
8. Cut the engine harness conduit (1) at the shown location.
Important: Make the cut as close to the harness breakout as possible.
9. Cut the 2 twisted wires on the engine side of the 2 heat shrink sealed splices.
10. Remove the wheel speed sensor wiring from the engine harness.
11. Lower the vehicle. Refer to Vehicle Lifting.