DeVille DHS V8-4.6L VIN Y (2000)
7. Remove the caliper from the anchor and support.
8. Remove the inboard and outboard pads from the anchor bracket.
9. Remove and inspect the pad retainers.
Important: Inspect the caliper bolt suspension boots for cuts, tears, or deterioration. If damaged, replace the pin boots. Refer to Brake Caliper
Bracket Overhaul. Inspect the piston boot for deterioration. If damaged, Refer to Brake Caliper Overhaul -Front (J55). Inspect the caliper pin bolts for
damage or corrosion. Replace if damaged or corroded. Do not attempt to clean away corrosion. Corrosion is typically caused by damaged pin boots.
Installation Procedure
1. Install the brake pad retainers into the caliper anchor bracket.
2. If new brake pads are being installed in the vehicle it may be necessary to bottom the caliper pistons completely into the caliper bore.