DeVille DHS V8-4.6L VIN Y (2000)
Important: The caliper piston boots must lay flat. Make sure convolutions are tucked into place.
3. Use a small plastic or wooden tool (1) to lift the inner edge of the boot next to the piston (2), and press out any trapped air.
4. Install the caliper down over the brake pads and onto the anchor bracket.
Notice: Refer to Fastener Notice in Service Precautions.
5. Insert the caliper slide pins.
^
Tighten the caliper slide pins to 85 Nm (63 ft. lbs.).
6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
7. Lower the vehicle.