DeVille DHS V8-4.6L VIN Y (2000)
Turn Signal Switch: Service and Repair
Disassemble
Disassembly Procedure
Important: Do not remove the wire harness straps for the turn signal and multifunction switch assembly procedure when removing the upper and
lower shrouds.
1. Remove the upper and lower shrouds. Refer to Steering Column Trim Covers - Disassemble - Off Vehicle (Power Tilt/Telescope-Column Shift) or
Steering Column Trim Covers - Disassemble - Off Vehicle (Power Tilt and Telescope, Floor Shift) or Steering Column Trim Covers -
Disassemble - Off Vehicle (Manual Tilt, Floor Shift) or Steering Column Trim Covers - Disassemble - Off Vehicle (Manual Tilt, Column Shift).
2. Disconnect the connector(s) from the turn signal and multifunction switch assembly (3).
3. Remove the 2 pan head tapping screws (1) and (2) from the turn signal and multifunction switch assembly (3).
4. Remove the turn signal and multifunction switch assembly (3) from the steering column.
