DeVille DHS V8-4.6L VIN Y (2000)
Turn Signal Switch: Service and Repair
Assemble
Assembly Procedure
1. Install the turn signal and multifunction switch assembly (3) onto the steering column.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the lower pan head tapping screw (2) first.
Tighten the lower pan head tapping screw to 2.5 Nm (22 inch lbs.).
3. Install the top pan head tapping screw (1) last.
Tighten the top pan head tapping screw to 2.5 Nm (22 inch lbs.).
4. Connect the connector(s) to the turn signal and multifunction switch assembly (3).
5. Install the upper and lower shrouds. Refer to Steering Column Trim Covers - Assemble - Off Vehicle (Power Tilt/Telescope-Column Shift) or
Steering Column Trim Covers - Assemble - Off Vehicle (Power Tilt and Telescope, Floor Shift) or Steering Column Trim Covers - Assemble -
Off Vehicle (Manual Tilt, Floor Shift) or Steering Column Trim Covers - Assemble - Off Vehicle (Manual Tilt, Column Shift).