DeVille DHS V8-4.6L VIN Y (2000)
8. Place the transmission in PARK.
9. Using J28733-B separate hub and bearing from the drive axle.
Important: The hub and bearing are replaced only as an assembly.
Installation Procedure
Important: Clean rust and foreign material from the knuckle mounting face, bore and chamfer to allow for proper seating of the bearing and knuckle.
Important: Do not handle the knuckle or hub assembly by the ABS sensor wire.
1. Place the transmission in neutral.
2. Install the dust shield, taking care not to damage the bearing outboard lip seal.
3. Install the hub and bearing to the drive axle. Apply a light coating of grease to the knuckle bore. If the new hub and bearing has a protective plastic
cover, remove it before installation.
4. Install the drive axle nut and draw hub and bearing onto the axle.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the hub and bearing bolts.
Tighten the hub and bearing bolts to 130 Nm (96 ft. lbs.).
