DeVille DHS V8-4.6L VIN Y (2000)
6. Install the front wheel speed sensor connector and clip to the dust shield.
7. Install the rotor. Refer to Brake Rotor Replacement - Front (Without J55) or Brake Rotor Replacement - Front (J55) in Brakes and Traction
Control.
8. Install the caliper and caliper bolts. Refer to Brake Caliper Replacement - Front (Without J55) or Brake Caliper Replacement - Front (J55) in
Brakes and Traction Control.
9. Insert a large, flat bladed tool (1) into the caliper and rotor to prevent the rotor from turning.
Tighten the wheel drive shaft nut to 160 Nm (118 ft. lbs.).
10. Install the wheel and tire.
Tighten the wheel nuts to 125 Nm (80 ft. lbs.).
11. Lower the vehicle.
Wheel Bearing/Hub Replacement - Front (FE7)
FRONT WHEEL BEARING/HUB
Removal Procedure
^
Tools Required
-
J28733-B Wheel Hub Remover
Important: The hub and bearing are replaced only as an assembly.
1. Raise the vehicle and support by the frame allowing the control arms to hang free. Refer to Vehicle Lifting.
2. Remove the wheel and tire. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
