DeVille DTS V8-4.6L VIN 9 (2002)
Front Door Window Regulator: Service and Repair
Window Regulator Replacement - Front Door
Removal Procedure
Caution: Refer to Express Window Down Caution in Cautions and Notices.
Important: This vehicle is equipped with express up, torque sensitive window on the front door windows.
When the battery or the power has been removed from the front door module, the front door module will need to be reprogrammed after
power is restored and all repairs are completed.
1. Remove the door trim panel. Refer to Trim Panel Replacement - Side Front Door (See: Front Door Panel/Service and Repair) .
2. Remove the door module. Refer to Door Control Module Replacement.
3. Remove the water deflector. Refer to Water Deflector Replacement - Front Door See: Front Door Panel/Service and Repair.
4. Remove the inside handle assembly (4) in order to gain access to the window clamp attachment bolts:
1. Carefully pry the front of the assembly (4) rearward.
2. Pull the front of the assembly (4) outward.
3. Slide the assembly (4) rearward to remove.
5. Disconnect the handle rod (3) from the clip guide (2).
Caution: Refer to Express Window Down Caution in Cautions and Notices.
6. Reconnect the power window switch and module.
7. Raise the window to the full up position.
8. Tape the window in place.
Caution: Refer to Glass and Sheet Metal Handling Caution in Cautions and Notices.
9. Loosen the window clamp attachment fasteners.
10. Lower the regulator clamps (2) to the full down position.
