DeVille DTS V8-4.6L VIN 9 (2002)
*
The alignment datums (4)
*
The electrical connector
*
The armrest pull handle retainer clips (3)
*
The eight retainers
Caution: This screw must be properly installed. This screw is critical in order to maintain retention of the inside handle to the slider-glide
mechanism. Failure to properly install this screw may allow the door to unlatch during a collision, resulting in personal injury.
Notice: Refer to Fastener Notice in Cautions and Notices.
6. Install the screw attaching the inside door handle to the sheet metal.
Tighten the screw to 0.5 N.m (4 lb in).
7. Install the inside handle bezel to the inner door panel in the following order:
1. Hold the inside handle to the open position.
2. Insert the rear hook on the bezel to the wood trim tab.
3. Press the forward end of the bezel inward until it is fully seated.
Important: Ensure the manual lock rod is in the full up/unlocked position.
8. Position the manual lock knob (1) into the bezel opening until the locking clip (2) bottoms out on the bezel.
9. Engage the locking clip (2) located at the front of the lock knob (1) to the lock rod.
