Fleetwood FWD V8-300 4.9L (1993)
3.
Align new molding to the middle of the two rear quarter panel slots. Refer to Figure 1. Front stud will not align with the existing hole in the quarter
panel. Mark new hole location on quarter panel using a grease pencil, or equivalent, or apply white-out correction fluid, or equivalent, to the tip of
the stud and touch the panel.
4.
Mark location with a center punch and drill 6.4 mm (1/4") hole at new location and clean up any burrs.
5.
Remove the barrel nut from the old hole and discard.
NOTICE:
Protect vehicle from any overspray in steps 6 and 7. This could be accomplished using a Q-tip or small artist's paint brush, or equivalent, to apply primer
and wax.
6.
Treat old and new hole with primer and allow to dry.
7.
Apply wax spray, P/N 12345489, to old and new hole for added corrosion protection.
8.
Insert new barrel nut from service kit into new hole.
9.
Install new molding per Service Information Manual instructions, Section 10-7. Adhesive tape from new molding should cover the old hole.
For warranty purposes use Labor Operation T1949 at .4 hour (one side) with .3 hour for additional side.
Parts are expected to be available on February 23, 1993.
