Seville STS V8-4.6L VIN 9 (1998)
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
5. Install the hub and bearing bolts.
Tighten the hub and bearing bolts to 130 Nm (95 ft. lbs.).
6. Install the front wheel speed sensor connector and clip to the dust shield.
7. Install the rotor.
8. Install the caliper and caliper bolts. Refer to BRAKE CALIPER REPLACEMENT.
Tighten the caliper bolts to 51 Nm (38 ft. lbs.).
9. Insert a drift punch (1) or screwdriver into the caliper and rotor to prevent the rotor from turning.
Tighten the wheel drive shaft nut to 145 Nm (107 ft. lbs.).
10. Install the wheel and tire.
Tighten the wheel nuts to 140 Nm (100 ft. lbs.).
11. Lower the vehicle.
