Seville STS V8-4.6L VIN 9 (1998)
4. Connect the ABS electrical connector.
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
5. Install the stabilizer link bolt and nut.
Tighten the stabilizer link bolt nut to 15 Nm (11 ft. lbs.).
6. Install the electronic level control height sensor link on left control arm.
7. Install the rear suspension support assembly.
8. Lower the vehicle to obtain trim height.
9. Tighten the control arm nuts.
Tighten the control arm nuts to 80 Nm (59 ft. lbs.).
Control Arm Bushing Replacement
REMOVAL PROCEDURE
^
Tools Required
-
J 21474-4 Long Nut
-
J 21474-27 Long Bolt with Thrust Bearing
-
J 41014-1 Bushing Remover
-
J 21474-01 Control Arm Bushing Service Set
1. Remove the control arm from the vehicle. Refer to REAR AXLE LOWER CONTROL ARM Replacement.
