SRX 2WD V8-4.6L VIN A (2004)
3. Install the HVAC module into the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the upper left HVAC module mounting nut (1).
Tighten
Tighten the nut to 9 N.m (80 lb in).
5. Install the lower left HVAC module mounting nut (1).
Tighten
Tighten the nut to 9 N.m (80 lb in).
6. Connect the rear heater ducts to the HVAC module.
7. Connect the drain tube to the bottom of the HVAC module.
8. Connect the drain tube (2) to the floor.
9. Connect the HVAC electrical connector.
10. Install the air inlet assembly.
11. Install the I/P carrier.