SRX 2WD V8-4.6L VIN A (2004)
7. Carefully remove the upper control arm to knuckle retaining nut.
8. Using J 43631 carefully separate the upper control arm from the knuckle.
9. Notice: Avoid tool contact to the outer constant velocity boot seal when removing the wheel bearing mounting bolts. Failure to observe this notice
may result in damage to the CV boot.
Carefully remove the wheel bearing/hub retaining bolts.
10. Install J 45859 to the vehicle.
11. Using J 45859 carefully separate the wheel driveshaft from the wheel bearing/hub.
12. Remove the wheel bearing/hub from the vehicle.
Installation Procedure