SRX 2WD V8-4.6L VIN A (2004)
1. Notice: Refer to Fastener Notice in Service Precautions.
Notice: Avoid tool contact to the outer constant velocity boot seal when removing the wheel bearing mounting bolts. Failure to observe this notice
may result in damage to the CV boot.
Install the wheel bearing/hub to the vehicle.
2. Install the wheel bearing/hub retaining bolts.
Tighten the bolts to 125 Nm (92 ft. lbs.).
3. Install the upper control arm to the knuckle.
4. Install the upper control arm to knuckle retaining nut.
Tighten the upper ball joint nut to 20 Nm (15 ft. lbs.) plus a additional 210 degree turn.