SRX 2WD V8-4.6L VIN A (2004)
Wiper Arm: Service and Repair
Wiper Arm Replacement
WIPER ARM REPLACEMENT
TOOLS REQUIRED
J39822 Wiper Arm Puller
REMOVAL PROCEDURE
1. Set the wipers in the Park position.
2. Open the hood assembly.
3. The driver side wiper (4) aligns with an orange line at the tip of the wiper blade located at the center lower windshield.
4. The passenger side wiper (1) aligns with an orange dot at the tip of the wiper blade located on the right lower side of the windshield.
5. Remove the covers (2,5) from the wiper arm nuts (3,6).
6. Remove the nut (3,6) from the wiper arm drive spindle.
NOTE: Apply pressure only at the end of the liftgate/hood assist rod that you are removing or attaching. Do NOT apply pressure to the middle of the
rod because damage or bending will result.
7. Remove the upper hood assist rods from the assist rod ball studs (1) it removing the driver side wiper arm.
8. Tilt the hood rearward to the air inlet grille panel.
9. Support the hood assembly.
IMPORTANT: Use the J 39822 in order to remove the wiper arm it the wiper arm tails to loosen from the wiper arm drive spindle.
