SRX 2WD V8-4.6L VIN A (2004)
10. Remove the wiper arm from the wiper arm drive spindle.
11. Clean the drive spindle knurls with a fine wire brush.
12. Remove the wiper blade from the wiper arm.
INSTALLATION PROCEDURE
1. Install the wiper blade onto the wiper arm.
2. Position the passenger side wiper arm so the wiper blade tip (1) aligns with the orange dot on the lower outer edge of the windshield.
3. Position the driver side wiper arm so that the wiper blade tip (4) aligns with the orange line on the lower center of the windshield.
4. Install the wiper arm onto the wiper arm drive spindle.
NOTE: Refer to Fastener Notice in Service Precautions.
IMPORTANT: Hold the wiper arm into position while tightening the nut.
5. Install the nut (3,6) on the wiper arm.
Tighten
Tighten the nut to 35 N.m (26 lb ft).
6. Secure the upper hood assist rods onto the assist rod ball studs (1) located on the hood assembly.
7. Install the wiper arm nut covers.
8. Close the hood assembly.
