SRX RWD V8-4.6L VIN A (2006)
4. Push the panel inward in order to secure the retainers.
5. Install the seat belt retractor anchor bolt (3). Ensure that the belt is not twisted.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the bolt to 45 N.m (33 lb ft).
6. Install the seat belt retractor guide bolt (1). Ensure that the belt is not twisted.
Tighten the bolt to 70 N.m (52 lb ft).
Garnish Molding Replacement - Center Pillar
GARNISH MOLDING REPLACEMENT - CENTER PILLAR
TOOLS REQUIRED
J 38778 Door Trim Pad Clip Remover
REMOVAL PROCEDURE
1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 2 and SIR Disabling and Enabling Zone 6 in Restraint Systems.
CAUTION:
-
Refer to SIR Caution in Service Precautions.
-
In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door pillar in the
area of the side impact sensor (SIS). Turn OFF the ignition and remove the key when performing service in the area of the SIS.
2. Remove the front carpet retainers.
3. Remove the rear carpet retainers.
