SRX RWD V8-4.6L VIN A (2006)
Trim Panel: Procedures
Garnish Molding Replacement - Body Side Rear Upper (With RPO Code TB5)
GARNISH MOLDING REPLACEMENT - BODY SIDE REAR UPPER (W/TB5)
REMOVAL PROCEDURE
1. Remove the seat belt retractor guide bolt (1).
2. Remove the seat belt retractor anchor bolt (3).
3. Remove the liftgate rod cover and liftgate rod.
4. Remove the garnish molding (1).
5. Slide the seat belt through the garnish molding.
INSTALLATION PROCEDURE
1. Insert the seat belt through the garnish molding.
2. Insert the seat belt guide into the garnish molding.
