STS RWD V8-4.6L (2007)
20. The J 28467-87 is used to lift the engine once the engine is removed from the vehicle.
21. Remove the ground strap from the right rear cylinder head and bolt the J 28467-87 in position.
22. The J 28467-87 and the J 28467-86 can now be used to lift the engine.
Removal Procedure
1. Unscrew the lift hooks (1) and remove them from the lift bracket and the support brackets. Remove the lift hooks from the tube assemblies.
2. Remove the front tube and support assemblies from the main support beam.
3. Remove the main support beam assembly.
4. Remove the J 28467-15 from the right cylinder head.
Notice: Refer to Fastener Notice.
5. Install the front wire harness bracket bolt.
Tighten the wire harness bracket bolt to 45 N.m (33 lb ft).
6. Remove the J 28467-86 from the left cylinder head.
7. Install the push pin securing the wiring harness to the left cylinder head.
8. Install the fuel injector sight shield.
