STS RWD V8-4.6L (2007)
25. Remove the J 45930-A from the crankshaft.
26. Wipe off any excessive sealant from the block.
27. Ensure the new cassette style crankshaft rear oil seal is installed properly.
*
The outer surface of the seal (3) should be 0.500-0.800 mm (0.0197-0.0315 in) (1) below the surface of the engine block (2).
*
The inner surface of the sleeve (6) should be 0.400-0.900 mm (0.0158-0.0354 in) (4) below the surface of the outer surface of the seal (5).
*
The installed seal and sleeve need to be parallel to the block by 0.000-0.500 mm (0.000-0.0197 in).
28. Clean all tools to remove any residual sealant.
29. Install the flywheel.
