STS RWD V8-4.6L (2007)
1. Install new O-rings.
2. Install the discharge hose.
3. Connect the discharge hose to the compressor.
Notice: Refer to Fastener Notice.
4. Install the discharge hose bolt.
Tighten the bolt to 5.4 N.m (48 lb in).
5. Connect the discharge hose to the compressor.
6. Install the bolt to the discharge hose.
Tighten the bolt to 9.8 N.m (87 lb in).
7. Install the engine splash shield.
8. Install the LH wheel and tire.
9. Install the air deflector.
10. Evacuate and recharge the refrigerant system. Refer to Refrigerant Recovery and Recharging.
11. Using J 39400-A, leak test the fittings of the component.
