Aveo L4-1.6L (2008)
Brake Shoe: Testing and Inspection
Brake Shoe Inspection
Inspection Procedure
1. Remove the brake drum. Refer to Brake Drum Replacement (See: Brake Drum/Service and Repair).
Caution: Refer to Brake Dust Caution (See: Service Precautions/Technician Safety Information/Brake Dust Caution).
2. Measure the lining thickness.
The minimum lining thickness is 0.5 mm (0.02 in).
Important: Replace the shoe and lining assembly in axle sets only.
3. If the lining thickness is less than the specification, or if a defect is found, replace the linings. Refer to Brake Shoe Replacement (See: Service and
Repair).
4. Install the brake drum. Refer to Brake Drum Replacement (See: Brake Drum/Service and Repair).
