Blazer 4WD V6-4.3L VIN X (2005)
4. Connect the accelerator cable (1) to the bracket clip (2).
5. Install the accelerator cable onto the throttle body.
6. Ensure that the cable is fully seated in the pulley groove. The cable must not lie outside of the hook tab.
7. Install the accelerator cable to the accelerator cable control bracket.
8. Install the accelerator cable to the cable routing bracket.
9. Install the air cleaner outlet duct.
10. Use the following procedure in order to inspect the accelerator pedal operation.
IMPORTANT: The accelerator pedal should operate freely without binding between closed and wide open throttle.
1. Turn ON the ignition, with the engine OFF.
2. Using a scan tool, observe the parameter for the throttle position (TP) sensor.
3. Depress the accelerator pedal to the floor.
4. Release the accelerator pedal.
5. Verify the throttle position has gone from 0 percent to 100 percent and back to 0 percent.
11. Install the left closeout/insulator panel.
