C 2500 Suburban 2WD V8-8.1L VIN G (2001)
1. Install a NEW valve rocker arm cover gasket if the gasket was removed from the rocker arm cover.
2. Install the valve rocker arm cover.
3. Install the valve rocker arm cover bolts.
Notice: Refer to Fastener Notice in Service Precautions.
4. Tighten the valve rocker arm cover bolts in sequence using two passes as shown.
4.1.
Tighten the valve rocker arm cover bolts a first pass to 6 Nm (53 inch lbs.).
4.2.
Tighten the valve rocker arm cover bolts a final pass to 12 Nm (106 inch lbs.).
5. Install the ignition coil wiring harness (left side shown, right side similar).
6. Install the ignition coil wiring harness bolts.
^
Tighten the ignition coil wire harness bolts to 12 Nm (106 inch lbs.).
7. Install the CPA retainers at the ignition coils.
Important: Fully install the spark plug wire by pushing on the exposed end of the spark plug boot. Do not push the spark plug wire on the spark plug
by using the metal heat shield.
