C 3500 HD Truck 2WD V8-8.1L VIN G (2002)
14. If replacing the valve rocker arm cover, remove the ignition coil bolts. (Left side shown, right side similar).
15. Remove the ignition coils.
Installation Procedure
1. If replacing the valve rocker arm cover, install the ignition coils. (Left side shown, right side similar).
Notice: This bolt is a self-tapping bolt. If installing this bolt into a new component, installation of the bolt may be difficult. Ensure that the bolt is not
over-torqued during the initial installation (thread cutting). Failure to limit torque can lead to bolt failure.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the ignition coil bolts.
Tighten the ignition coil bolts to 12 Nm (106 inch lbs.).
3. If replacing the valve rocker arm cover, install the CPA retainers at the ignition coils.
